FIAT PALIO 2011 KEY LOST ....... MADE IN BRAZIL

[achaccha]

Dear friends.
I searched the immobilizer module or BSI for this Fiat Palio of 2011 (made in Brazil) but not found. I've been monitoring the two connector cables Antenna amplifier, these two wires go directly to the dashboard. immo means that is in the dashboard. can please confirm if this is true? eprom or microprosedador that must be read in the instrument panel to program the key and start the engine of this vehicle? I understand that the key transponder is a tp08.
attached images of the dashboard and the engine ECU.
Thanks for your help

[topclef]

Yes , IMMO-DATA in the Dashbord , Tmpro can do it with Module 100


Sent from my Nokia 3310 using MIR Station

[amper]

http://www.digital-kaos.co.uk/forums/f177/pre-coded-fiat-267712/

[achaccha]

Thanks friends for their comments. in the dashboard can not see a memory known. I think that would be the one in the attached image. 2904 will be the eprom? as I should read this eprom?
Thanks for your help

[Lamparita]

Hi.
Should read eeprom 95160 or 24C16
Best regards
Lamparita

[Lamparita]

Hi.
Should read eeprom 95160 or 24C16
You must remove the needles of watches
Best regards
Lamparita


192688

[achaccha]

Dear Friend.
can not see any EPROM with that nomenclature 95160 nor is there an 24C16.
the closest is only that you can see in the picture and says:
2904
ST B927
Now I can see friend "Lamparita". then I have to disassemble the board a little more and remove all needles
thanks for your help

[thunderwinged]

Hi this dash use 24C16 ,you need remove pointers because memory in outher side of board

[thunderwinged]

you have outher key working?? make clone only

[achaccha]

you have outher key working?? make clone only

I have understood that the key to this vehicle uses a TP08, it is possible to clone the transponder?
can say that tool to use to clone this tp08?
Thank you for your help.

[Meat-Head]

Is it not eaiser to get key from dealer and code and add yo memory

[thunderwinged]

I have understood that the key to this vehicle uses a TP08, it is possible to clone the transponder?
can say that tool to use to clone this tp08?
Thank you for your help.

you Have Key RED? if have is easy codifing key blue again

[Lamparita]

Hello.
Transponder TP-08 or ID-48 is not clonable, this model has no red key immobilizer
Carries a pre-coded ID-48, which can generate module 100 TMPro or Scanner OBDMap
Best regards
Lamparita

[achaccha]

Hello Friends.
24C16 EPROM found the other side of the printed board.
Please can you help me with the precode and pin code?
Thanks for your help

[Lamparita]

Hi.
Pin Code: 17637
For precode is slightly more difficult
Best regards.
Lamparita.

[leandroks]

you Have Key RED? if have is easy codifing key blue again
Hi m8 u r confunding immo box and dashboard, the old immo box (black one can be clonned) t11, the dash new ones is id48 like vw, it is not and as long as i know will never be conable, the dashboard model does not use red keys, they are programmend with precoded transponders...