Mercedes A Class 160 error Star

[MilanAdewa]

Hello brothers, someone could correct me the problem of error Star Mercedes A Class 160

[Babos]

try this one.

[MilanAdewa]

Thank you my brother, I'll give you the result

[MilanAdewa]

Hi my brother, I will try the file once the car starts and displays error star

[fear_dark]

send dump 24c04

[Babos]

before your car not star?
now car started but in dashboard you have start error?
Write more aboute this ecu! edc15c0 or other what eeprom he have maybe 24c04 or 24cXX

[MilanAdewa]

The ecu number is ( A 166 150 01 79) there are no n 24c04 eeprom

[MilanAdewa]

I also post the file dashboard?

[fear_dark]

try it and report!!!!

[DOUGLASDL]

It should inform time that the tips below were tested only on line MB successfully, and can be made across the line MB which uses the system.


TIP 1 ?
a) Turn the ignition key and turn on and off 08 times in less than 10 seconds. In the eighth inning to stop the act in point 2.
"This tells the security system in the car to change the programming mode"
b) Press one of the buttons on the remote you want the car to recognize.
"Most of these vehicles have remotes at least four buttons
on the remote control. "
c) Turn off and wait a few seconds and then connect and sync and be done.
"If no synchronization or over a button to be programmed CR
run the process again "


TIP 2 ?


a) Put the key in the cylinder and turn to position 2.
b) Remove the key and hold the lock button, while tightening and loosening the unlock button 5 times
c) Stop pressing buttons. Press the lock or unlock any, the key is programmed.
"This procedure should be completed in less than 10 seconds."

[MilanAdewa]

hi fear_dark you the coding?

[fear_dark]

no need coding

[MilanAdewa]

when I load the v2 there is a relay that flashes v1 also flash the same relay

[MilanAdewa]

V2 file does not display error star, but the relay in the fuse box has flash. V1 file displays error star and flash relay also, you have an idea? the car still does not start

[pepi]

You will need MB Star diagnose. First check on actual values of ECU for start enable if no set ECU to virgin and adapt with star diag. Also check the immo file.

[MilanAdewa]

Thank you brother, I'll do it tomorrow

[MilanAdewa]

hi the brothers, called me if the ecu mercedes A Class is version1 or version2?