View Full Version : 07-10 nissan maxima
XmoDDeR
17th April, 2013, 08:11 PM
programming method chip type calcs any information on doin 07-10 nissan maxima
also power up and other locations if any
thanks
afitijuana
17th April, 2013, 10:00 PM
just cluster bdm in back line 60
XmoDDeR
17th April, 2013, 11:56 PM
just cluster bdm in back line 60
have a picture a calc
mojomojo
19th September, 2013, 05:00 AM
Can some please help me with this car? I have been trying to program with the USA prog and it keeps failing when it tries to write it bAck. I have contacted smelcom with no success. Here is a dump of what I have read. Should I remove the EPROM 93c66?
Another problem I have is that when I put the dash back the message center is blank but the back light is lit. Could it have been the the LCD ribbon on back? I will look at it again tmrw but I would like anyone with experience on this to please help me thx!
afitijuana
19th September, 2013, 07:18 AM
It's strongly recomend to always remove the epprom.
Where is you dump file ?
post it
Chances are that the chip is fryed.
Try to read it and write a couple times to make sure is ok, check the solder points and lest but not last the xtrail bridge if you make one.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.