mitsubishi colt etacs

[locks85]

Hi all, car wont start, i read etacs in circuit with xprog m original and tango doesnt recognise file so should be corrupted. Is it possible to get paired dumps or for original dump to be corrected ? COLT ECU A135 150 20 79 AND ETACS MN108319
Regards
locks85

[mcgywer]

Hi,
have same problem.

Car won't start. AVDi shows errors:
- Etacs - vin not rpogrammed correctly - but when conect in live data shows vin correct.
- ECU - transponder key
- Gearbox - eerpom error data wrong.

Any idea?

Here's my eeproms from ECU and ETACS.

Regards
Mat

[mcgywer]

Read again ETACS with shcema from NYo and eeprom is OK. Does anyone have set of dumps ecu 24CS08 and ETACS 3L40K?

[simon77]

if you have mut tool all you need to do is program vin . first program an incorect vin in etacs then reprogram correct vin that will sort out the error. then code keys and sync engine to etacs i have done this many times
regards

[mcgywer]

Does anyone have pair of dumps - ECU and ETACS?

Regards
Mat

[mcgywer]

Hi,
here's pair of dumps after syncho and key - program with AVDI.

On dash get "0" and no crank - in gear box error - "eeprom data wrong"

Any idea

Mat

[mcgywer]

Hi,
have write second eeprom into ECU make synchro with AVDI - car starts - everything fien.

Here's pair of working dumps.

Regards
Mat

[simon77]

no need for new dump write into etacs incorrect chassis number,program etacs with incorrect chassis number close switch open switch. now re-program etacs with the correct chassis number program keys job done. i have don this many time after a flat battery.
regards

[cdex]

Does the paired dumps need syncro? or just make new key?