darwins
23rd April, 2013, 10:11 PM
Hello Friends
Before anyone says China Crap I do not do chip tuning, I bought this silver box (Image attached) last August - September with EDC17 reading in mind.
I used this a couple of times once for a MEV 17 which I cloned, the car ran fine afterwards, image attached..
I pulled it out yesterday to do the same job, I have 2 ecu's get same result with both.
During connect it stops at 33% needs rebooting then it stops at 66% needs rebooting then it goes to 100% Image attached..
During reading again it gets to 33% sit's there for a while then screen asks for reboot, at this point the error message displays Image attached..
Anyone seen this ?
It seams like a boot issue, I have played with different resistors etc. Any hardware upgrade suggestions?
Or maybe a link to some thing which works :)
Regards
Darwins
Before anyone says China Crap I do not do chip tuning, I bought this silver box (Image attached) last August - September with EDC17 reading in mind.
I used this a couple of times once for a MEV 17 which I cloned, the car ran fine afterwards, image attached..
I pulled it out yesterday to do the same job, I have 2 ecu's get same result with both.
During connect it stops at 33% needs rebooting then it stops at 66% needs rebooting then it goes to 100% Image attached..
During reading again it gets to 33% sit's there for a while then screen asks for reboot, at this point the error message displays Image attached..
Anyone seen this ?
It seams like a boot issue, I have played with different resistors etc. Any hardware upgrade suggestions?
Or maybe a link to some thing which works :)
Regards
Darwins