FG Tech Silver Box Clone Tricore Boot Issue ?

[darwins]

Hello Friends

Before anyone says China Crap I do not do chip tuning, I bought this silver box (Image attached) last August - September with EDC17 reading in mind.

I used this a couple of times once for a MEV 17 which I cloned, the car ran fine afterwards, image attached..

I pulled it out yesterday to do the same job, I have 2 ecu's get same result with both.

During connect it stops at 33% needs rebooting then it stops at 66% needs rebooting then it goes to 100% Image attached..

During reading again it gets to 33% sit's there for a while then screen asks for reboot, at this point the error message displays Image attached..

Anyone seen this ?

It seams like a boot issue, I have played with different resistors etc. Any hardware upgrade suggestions?

Or maybe a link to some thing which works :)

Regards

Darwins

[gezame]

Hi
Seems bad boot-pin.
look good in fgtec instructions to mev17, there are several different PCB
BR.

[darwins]

I will double check but the pcb looks the same as the one I did that worked.

[darwins]

This is the PCB I have anyone have other boot options ?