AUDI GAMMA CC AUZ5Z3P ST61907 epron dump code need

[mexanico1971]

Hi !
got this gamma CC from panasonic , wend I read the dump of st61907 the content is FF FF FF or 00 00 00 !
I try to read it as nm93c06 width xprog no data ! always say pin 6 bad conctact !
I try to read it width UPA ori as st61907 no data wend I write "20 error"s"
and it"s impossible to write it in both devices !
what do I have to do ?!!!!!

is this inverted pins ?!

any ideias ?!

all inf about it !

audi gamma cc 4A0 035 186 made in Japan ! not Deep Purple LP ! :-)
AUZ 5Z3P0064605

I found dump"s to for the radio !

thank"s in advance

some pic"s of the radio

[cole_mcs]

Hi !
got this gamma CC from panasonic , wend I read the dump of st61907 the content is FF FF FF or 00 00 00 !
I try to read it as nm93c06 width xprog no data ! always say pin 6 bad conctact !
I try to read it width UPA ori as st61907 no data wend I write "20 error"s"
and it"s impossible to write it in both devices !
what do I have to do ?!!!!!

is this inverted pins ?!

any ideias ?!

all inf about it !

audi gamma cc 4A0 035 186 made in Japan ! not Deep Purple LP ! :-)
AUZ 5Z3P0064605

I found dump"s to for the radio !

thank"s in advance

some pic"s of the radio

hello friend,take this ,is good cheked by me

[mexanico1971]

thank"s Cole !
I fourget to came to post say that"s was solved !
my real problem was write the ST61907 !
try it from many ways as ! ST61907 NM93c06, M93c06 ,46, 66 but no luck !
even UPA ori can write it ! so I grab comum microwire and write it xprog !

thank very much Cole !

[auto12volts]

[QUOTE=mexanico1971;1965793]thank"s Cole !
I fourget to came to post say that"s was solved !
my real problem was write the ST61907 !
try it from many ways as ! ST61907 NM93c06, M93c06 ,46, 66 but no luck !
even UPA ori can write it ! so I grab comum microwire and write it xprog !

Hi, i have same problem with this radio , i can't program st61907, i tried to program the file that you found on 93c66 but radio always on "Safe"
Can you tell me if i need to do something with buttons to get out safe and put code, or it pass automaticaly??
Thanks

[Raimax]

Press together U and M buttons

[StefanF1]

Hello,

are we talking about this chip (=IC 602)?

Best
Stefan

721111