mazda 323f dizel 1999 year lost key

[mitext]

Hello! I have a Mazda 323f diesel lost key. Help to deal with it is Immo box is mitsubisshi BJ3D675G2C can not make a key file. Can anyone finds my PIN code via the ECU EEPROM 93c56 Danso RF3F18881C.And what is the procedure for synchronization?

[key]

pin-82958549

Hello! I have a Mazda 323f diesel lost key. Help to deal with it is Immo box is mitsubisshi BJ3D675G2C can not make a key file. Can anyone finds my PIN code via the ECU EEPROM 93c56 Danso RF3F18881C.And what is the procedure for synchronization?

[mitext]

try and post

[key]

transponder - 8C

try and post

[mitext]

what is the procedure for teaching the keys to the car, I found a description but it is not. apply it:First cut the key and put a 8C transponder in it, or you can use the key ordered from dealer.

Note:With this procedure minimum 2 keys can be programmed.

1- Give ignition on and off repeatedly 6 times with 1 second delay. After 6th cycle leave the ignition off.

2- Pats(immobiliser) light on the dashboard will blink fast for 5 minutes.Wait for 5 minutes.


3- Pats(immobiliser) light will start blinking slowly, now the system is ready for entering pin code manually.

4- When the pats(immobiliser) light is off, turn ignition on, each blink is counted as 1.

As in the sample pincode, for the first digit of the pin code, wait for 2 blinks and turn ignition off.

When the ignition is off after pats(immobiliser) light goes on and off turn ignition on, when the ignition is on, pats(immobiliser) light should blink 8 times(second digit of the pin code) after the 8th blink, when the immo light is off, turn ignition off.

When the ignition is off after pats(immobiliser) light goes on and off turn ignition on, when the ignition is on, pats(immobiliser) light should blink 7 times(third digit of the pin code) after the 7th blink, when the immo light is off, turn ignition off.

When the ignition is off, after the pats(immobiliser) light is on and off, turn ignition on, after entering all 8 digits of the pin code, pats(immobiliser) light should stay on solid, when the pats light is on solid turn ignition on, now the pats(immobiliser) light should go off, now turn ignition off and remove the key from ignition.

Put the second key to the ignition and give ignition on with this key, wait for pats(immobiliser) light to go off, after the light is off turn ignition off and wait for 30 seconds.

Both keys are ready programmed to start the vehicle.

[Fallen]

If the process does not start after on/off 6 times then the transponder is incorrect.