help key programming ford fiesta 2005

[rashid01]

hi i have problem with ford fiesta 2005 erase all key but car cannot start error code 1213 immoblizer number of key programmed blow less then 3 key i done ignation on of with frist key then second key then 3rd key but programmed key 0 plz help

[camil]

If you have now 0 keys programmed your only way is VCM/IDS plus incode/outcode to program at least 2 keys for the car to start.

[rashid01]

problem create when try to start car with none transponder key more then 10 time after that orignal key stop working i try to add key but can not then i erease all key via t300

[camil]

You now have to program at least 2 key for the car fo start. Don't know if your t300 can do it, i know VCM can.

[ninja123]

t300 can do this but you need to use incode outcode system, you would have needed to do this to erase keys too, and make sure that you are using correct transponders, should be ID63 for this one, not ID60.

ninja

[rashid01]

I used t300 with in code out code I have three original compny key id 4d 63 when I erase all key t300 say disconnect tester and cycle key I do every thing but security light flashing and 0 key in memry error code 1213

[rashid01]

plz help if the car show 0 key can I add key via tool or just cycle key like some other ford when erase all key just cycle two key then start I erase key t300 pats 3 with incode out code

[camil]

For use the cycle key method you need at least 2 keys already programmed in car. With 0 key programmed you need to go to PATS system with your t300 and with incode outcode program 2 new keys.

[rashid01]

thanks camil i will try to programme key and report back u

[ninja123]

cycle keys is for old pats systems, this will not work here, you need to program 2 keys before car will start.
if you use ids, you only need one incode for whole procedure.

ninja

[rashid01]

hi ninja 123 when I add key it say inter to next key back to exit but show 0 key when I inter next that say same after two or three key I inter exit but there 0 key is this car passible to immo off

[rashid01]

ecu siemens made in france 4s61-12a650-ya s120977021bsim210 1ata

[ninja123]

are you doing outcode/incode correctly? do you choose ad or dealer codes?

t300 is not the best for this system, i use ids every time, but i have used t300 on a 2005 ford and worked to 'add a key' with dealer incode.

ninja

[rashid01]

i used deller code and i used incode out code correct

[rabie_m]

POST DUMP AND KEY DATA

[rashid01]

POST DUMP AND KEY DATA can u tell me were is located immo box and wich ic i need to read dump

[ninja123]

immo is in dash, if ford cant program keys then I dont think you will program keys via obd, was car working ok when you have it or not working?

how many keys were programmed before you erased?

ninja

[rashid01]

there is 2 key in memry befor then i erese it customer try to start nontransponder key then working key stop work i try to add key cannot then i erase all key