OPEL EDC17 Tricore

[enigmauk]

198542

Does anyone know of a tool that can read/write this ECU? Seems Galletto/K-TAG doesn't support this one :(

Thanks

[Alpinesport]

every pro and ori tool it is a tc 1767 3 point and boot

[enigmauk]

Can you name one that does? I don't mind buying a tool to do this car just need to get job done!

Many dealers told me that this can be done but when they see the ECU pictures they told me their tool doesn't support it.

Thanks

[mislav88]

just put ecu in boot and read as any other 1767

pins 3 and 10 of tricore to gnd (via 1k resistor)
pin 4 to +3.3V (1k resistor)

if this dont work put also pin 32 to gnd

[mishu_b]

I have done many of this with FGTech 2 tool!

100% working

[enigmauk]

Where did you find the boot pin diagram and was the ECU exactly same as above?

[mtronik]

connection ecu

[mtronik]

pdf tricore galletto v3

[enigmauk]

PERFECT!!

will this work with galletto 2 though ?

Thanks

[mislav88]

now read my post #4 again...

yes it will work with fgtech2

[mishu_b]

as I told - I have done many of this with FGTech 2

[enigmauk]

OK to those above who said they did this ECU... no you DID not... i tested the ecu and the password is not supported by galletto... I could connect to ecu but unable to read int flash or eeprom.

You may have read TC1767.... which has been possible for a long time anyway....


Thanks...

[Nio]

I try to read this ecu with Fgtech2 v48 cinese clone and with no result.Make ID but not read.
Tomorrow i'll test with new Fgtech2 version 54 and post result. Regards.
Ktag read and write correctly this ecu. Regards.

[enigmauk]

I try to read this ecu with Fgtech2 v48 cinese clone and with no result.Make ID but not read.
Tomorrow i'll test with new Fgtech2 version 54 and post result. Regards.
Ktag read and write correctly this ecu. Regards.

I've just spoken to someone and they said that K-TAG doesn't support this ECU either...

Let me know how you get on with v54.

Thanks

[mamanacusa]

You got original readout over obd?

[enigmauk]

No i didnt do OBD.

[2200]

I try to read this ecu with Fgtech2 v48 cinese clone and with no result.Make ID but not read.
Tomorrow i'll test with new Fgtech2 version 54 and post result. Regards.
Ktag read and write correctly this ecu. Regards.

have you tried?

[enigmauk]

Nio.... did you test?/

[koz]

I have done many of this with FGTech 2 tool!

100% working

this ecu is currently not supported by any tool. Not CMD, not Byteshooter or FGtech ...

[enigmauk]

If you look from December 2012 this ecu inside the manual.... you still think its not supported?

or maybe just not supported by your clone?