Ford scape 2011 ecu programming

[llaverosv]

original ecu was damaged, have a new one, same label.
tried to program to vehicle using Advi pass-tru and internet connections to motorcrafservice.com .( short term suscription)


after running some steps a message is shown :the diagnostic tester is unable to comunicate with module...

please somebody know how to program ( or match) the new computer to the vehicle
what is the right procedure if usign Advi as pass ...

is there another procedure to follow ?

short term suscription ends in 20 hours or so

thanks for your help

[ominimicu]

swap immo eeprom

[llaverosv]

didnt see any eeprom, can help ?

[llaverosv]

just swap immo eeprom 95640 and done !
thanks

[easytech]

If it's a real original new blank ecu you have to program a calibration file on it with the As-build data derived from VIN.
I don't think this will work with just a pass-thru interface. Use IDS.
Since there is no calibration data immo swapping is useless.