quesion about a Programmer

[Salami]

Can I ask some help about smart card Programmer power voltage?

Please tel me if 9v or 12v ? to use for this programmer.
Thank you.

http://img99.imageshack.us/img99/4171/spa0014sp5.th.jpg (http://img99.imageshack.us/my.php?image=spa0014sp5.jpg)
http://img145.imageshack.us/img145/4021/spa0013by8.th.jpg (http://img145.imageshack.us/my.php?image=spa0013by8.jpg)

[jloys]

Check the number on the 3 legged device ( the one near the power socket ) if its 7805 you can put 9v or 12v , as this device will regulate the voltage to 5v. Be careful with the polarity of the power connector too
jloys

[jimbo69jones]

Thats no 7085 on that board, wrong casing. It's probably a 9v circuit looking at it (whats the number on that small transistor near the power input?) I reckon you'll be safe using a 9v power supply with a small current rating, I.e. around 200-350ma would me more than sufficient to drive that circuit.

[Salami]

Thats no 7085 on that board, wrong casing. It's probably a 9v circuit looking at it (whats the number on that small transistor near the power input?) I reckon you'll be safe using a 9v power supply with a small current rating, I.e. around 200-350ma would me more than sufficient to drive that circuit.

Is really hard o read the writing on the 3 legged transistor but I managedit it says: ~17AH - LW78L - 05ACZ.

After the identification of the voltage I need go and find the software for it in the internet.

I appreciate your help

<--Salami added 2 Minutes and 58 Seconds later...-->


Check the number on the 3 legged device ( the one near the power socket ) if its 7805 you can put 9v or 12v , as this device will regulate the voltage to 5v. Be careful with the polarity of the power connector too
jloys

thank you for your help as you can see above the reading of the transistor..

<--Salami added 5 Minutes and 28 Seconds later...-->

I also have Millenium 2001 and I don't know where to get software for it, if only can get software for either I will be able to use it. both are 9 pin serial connections.

[Salami]

Please Please Help.
I am *@@##off with the two programmer now I have bought a usb digitech and I can't get a driver for it, if any1 of you guys got one can you help and email me a copy I will sincerely appreciate it