View Full Version : Siemens sid803 pug407 problem
fes_786
3rd June, 2013, 05:27 PM
Hi guys
I'm trying to read a sid803 ecu
Tried with galleto v2 bdm and china bdm
Both wont read or detect ecu
Ecu getting power and drawing 1.6amp from psu
Ecu works ok on car
202051
I'm using china Siemens adapter
With wires soldered to board
Any help / ideas ?
assitutto
3rd June, 2013, 07:20 PM
che correct position for PIN1
in galletto documents there is bad information
Bild:Siemens SID 803.jpg - OBD-Wiki (http://wiki.obdtuning.com/?title=Bild:Siemens_SID_803.jpg)
waldi1979
3rd June, 2013, 07:51 PM
If I remember correctly - in this ECU power compsuntion is about 0,35A
fes_786
3rd June, 2013, 07:58 PM
Yes pinout was from that pic
Strange as I can read edc16 ecu ok
fes_786
5th June, 2013, 02:13 AM
i have ordered a spare ecu to test
will let u guys know
miha99
5th June, 2013, 07:32 AM
I use this info from DK
taurius
5th June, 2013, 09:17 AM
You also need to power both - the ecu and the bdm adapter.
Power the ecu on the specified pins - don't use main mass, use only the specified one.
fes_786
5th June, 2013, 03:04 PM
You also need to power both - the ecu and the bdm adapter.
Power the ecu on the specified pins - don't use main mass, use only the specified one.
What's main mass??
I know there's 2x 12v pins and 1gnd
G4 + c3 I think of the top of me head
Cheers 4 that pic too
fes_786
10th June, 2013, 06:23 PM
ok guys
cheers 4 pics
i found out my bdm adapter was wired wrong
i made a cable to go direct to pins
galleto v2 will detect but while reading it crashes
bdm100 will read and write ok
could some 1 check the attached dumps to make sure they not corrupt
and possibly dpf off via switch and delete all faultcodes related to addative ecu ???
and after u write mpc u have to press checksum button ??
thanks
assitutto
12th June, 2013, 09:24 AM
your mpc file is good and in this file only manual switch solution work, no volta, ecusafe or swiftech
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.