Manually insert 8C for Ford Ranger /Mazda BT50

[jamesnz888]

Hi All,

I have a 2010 Ford Ranger ( Mazda BT50) with all key lost, I managed to open a hole on ECU and got the codewords out. However I can NOT get it into programming mode with either 6 in-out or off-on methods.

Now I am wondering if someone can have a look my 8C key logic taken from Tango and insert into my ECU dump (95320). any help or advice is much appreciated.

[maligno]

Hello
The programming mode is not done as the manual says, is so, open driver door (courtesy light on) insert and remove the key 5 times and the light will blink fast, wait 5 minutes and slows the blinking .. . programming mode is finished.
Then insert the 8 digits.

221526

[curtpza]

maligno can you please help me with the codeword for my BT50 : 7719313477

[curtpza]

Not to worry maligno, i got it sorted

Cheers

[keygargoil]

jamez your code word is 31 26 19 52
and you need to do it by manually entering it cos the keys are in a immo box with hc805p18 processor

[makura]

HI
How do you get this car into programming mode?I have tried turnig the key on and off 6 times but the light will not flash fast as per instructions in the programming procedure,could some one who has done it(not read about it like me)help with the procedure that works.

[jamesnz888]

HI
How do you get this car into programming mode?I have tried turnig the key on and off 6 times but the light will not flash fast as per instructions in the programming procedure,could some one who has done it(not read about it like me)help with the procedure that works.

I have done it myself!. I had difficulty like you for the start, and then someone told me I have insert in and pull out key in a lightning fast speed for 6 times, even you have to insert in after half way out, do it very very fast. you will get it . good luck mate.

[helmov]

can u help in mazda bt 50 95320 ecu pin code

[helmov]

i found it big thx any way