NAVARA KEY HELP NEEDED.

[makura]

I have a nissan navara 2006 model,all the keys were lost.It has a BCM and in it i found 93c66 eeprom,now what i want to know is what mode the PCF7936 should be in,i have pin code but when i program the key the immo l.ight goes off but the car will not crank over,turn the key off and turn it back on the immo light starts flashing again,it seems the key is not being stored.

[sideshow]

ive had a similar problem with a 2003 pulsar, the owner supplied a chinese made key so I programmed it in with my scanner and car started then the next day they rang me up and said it wont start so I reprogrammed it and same thing , started ok then it stopped the next time they tried to start it, well I then went to Nissan and bought agenuine key and I programmed it and never had any probs after that, u should only need a good scanner to program in a new key with nissans even when all keys lost and u also need Nissan supercode software , so with nissans I always try to use genuine keys

[achaccha]

Dear Friend
While you might check contact switch, it is possible that the problem is in the switch or coil antenna. would be good scan and see that throws you fault code.
on the other hand suggest you post your dump for review.
regards

[makura]

Here is my dump,i dont think its the chip giving me problems.Should it be in password mode or something.

[makura]

Any other ideas?

[qwertyuiop12]

Hi, 2006 Nissan Navara chip 60 (4 d) or XX (4 d) If you know the PIN, record without problems or SBB MVP.Try

[keygargoil]

stop pal it needs a 2 button remote key that has a pcf7946 chip inytergrated into ita pcf7936 will not work this system

trust me

2 button remote key with pcf7946 will go straight in

[makura]

Now you are talking,thanks a million m8