2009 Civic 77960-SVA-A230-M1 problem after clear crash

[112005]

Hi, is there anyone who can help me to check these dumps, after clear the crash module is dead, no communication with scan tool airbag light is always on?

[rrador]

not a good clear, try this...pass in PM

[112005]

something is wrong still no communication and the yellow light for the passenger airbag doesn't come on at all

[rrador]

I think you have a different problem because even your clear dump should have had comm...did you try loading original dump and testing? How did you read, off the board or in circuit?

[112005]

I read it off the board. Now I'm going to load the original dump and test it. Is there a programmer capable to read and write this EEPROM in circuit?

[rrador]

If you read it off board make sure you put it back on right, orientation, soldering....I read these in circuit with carprog or UPA with special in circuit adapters.

[112005]

Last night I loaded with original dump and it's readable via OBD. Is there any virgin dump for this model?

[rrador]

I made a mistake in my last clear, this should work, same pass

[112005]

The clear dump is OK but i think there is a problem with the module. I load a brand new EEPROM with the clear dump and everything is OK just for the first ignition as soon as you turn the ignition off and then on again the light comes on and when I read the EEPROM again everything is scrambled. I don't know what's going on...