PDA

View Full Version : FGTech Galletto 2 Master Version48 CAN problem



miha99
19th June, 2013, 08:01 PM
I have FGTech Galletto 2-Master-Version48 like on pictures, everything works OK, this week I have a problem that
via OBD It wont work with ECUs on CAN bus.If anybody can point me where can be a problem.I measured the line to the
CAN transreceiver and everything is OK

mexanico1971
19th June, 2013, 10:02 PM
change U12 maybe the problem is from there !

good luck

BR

serdarmsc
20th June, 2013, 08:19 AM
http://www.digital-kaos.co.uk/forums/f173/fgtech-v51-3led-can-line-not-work-please-help-339245/

miha99
21st June, 2013, 07:42 AM
I replace CAN transreceiver, resistors on can line, relay and in the end I add CAN filter before transreceiver.Also all lines on pcb to lpc MCU are OK.
Any Idea what else can be?

camil
21st June, 2013, 08:23 AM
Your obd cable???

Broken solder joint on cable connector in pcb???

bondiblu
21st June, 2013, 08:38 AM
Only your cable/connector and MCU left

b2s15
21st June, 2013, 01:44 PM
hi, did it already work with can for other ecu ?
mine works great for can, great for edc16, but can't read any edc15v or p.
if you need i will can take a picture of mine.

miha99
22nd June, 2013, 08:10 AM
Yes please, my work on edc15 great.I also attach picture measured on can line when I push READ ECU in program,
so all lines all 100%, must be a problem in MCU or firware.