CELECT AND CELECT PLUS

[DALES TRUCK PARTS]

HI EVERYONE. I'M NEW TO THIS SO IF I DO SOMETHING INCORRECT PLEASE BE PATIENT I'M LEARNING. ANYWAY MY COMPANY IS WANTING TO START TESTING OR USED ECM'S AND IT UP TO ME TO FIND THE INFO. IF ANYONE COULD LET ME KNOW WHERE I COULD FIND WHICH WIRES I NEED TO MAKE MY OWN TEST PLUGS. THANKS IN ADVANCE!!

[Mxx20]

for bench cals or?

[DALES TRUCK PARTS]

YES TO TEST OFF ENGINES.

[Chadleynet]

Here is the information you will need to create the bench harnesses.

These are the wiring diagrams for each ECM - http://rapidshare.com/files/905738374/Celect%20and%20Celect%20Plus%20Diagrams.pdf (Not compiled by myself, sourced from somewhere else on this forum)
The last page of this document contains the ECM connectors, and the page before that should list the AMP pins required for the connectors - http://rapidshare.com/files/3450623356/Wiring%20Repair%20Connectors.pdf

-or-

If you're interested in buying the proper cables from Cummins: you will need the parent cable, and the segment that connects to the ECM. Those part numbers are listed here - http://rapidshare.com/files/334154479/Bench%20Calibration%20Cables.pdf

If you decide to make your own cables and require some help, feel free to message me!

[DALES TRUCK PARTS]

Thanks Chadleynet for the info. I have access to all of the plugs and harness. i just wasnt sure which wires i needed. thanks again