Vectra C Z19DTH DPF off

[kazikk]

Hi.
Could some one help me to turn off DPF in this file ?
Opel Vectra C Z19DTH 0281012868 - 1037384336
No EcuSafe or Volta please.
Thanks in advance.

210620

[kazikk]

Dos any one have 100% tested solution for this software ?

[mishu_b]

yes - 100% manual working solution!

[786mo]

Yes only manual solution works good on this car!

[786mo]

What did you read this file with? Can you do BDM read?

[kazikk]

i have read with Galletto by obd.

[786mo]

Can you read BDM?

[mishu_b]

it is working with the file read very well!
it is not mandatory to have BDM read!

[ominimicu]

1DE432";"DPF switch (0-no dpf & no lambda, 1 - dpf, 2 - lambda)";"1x1" i think applies to BDm read...your read seems a bit offset.. but you ll find it anyway.
and yes you can read write perfectly via OBD- you got 6 checksum blocks left out..but galletto will take care of that

[kazikk]

I have full BDM read,
At the moment i have 10 files from dieferent person,
main problem is that car go for 1 min after with some files i have fault : P2452-58
and some files not
but always car lose power.

211064

[smirnoff_rules]

check under car with engine cover removed and the metal pipe from the side of the dpf on the exhaust goes along the tunnel then turns up to the bulkhead and connects to a pipe similar to hard plastic fuel pipe only smaller,if its broken,that throws up the dpf sensor code because the gas isnt reaching the sensor

[kazikk]

pipe is OK.
i have try to disconnect and block sensor, no deferent

[ominimicu]

WIth switch solution all sensors must be plugged in and working!

[kazikk]

I have replace DPF pressure sensor for new one,
and still no power, every time i turn off and on ignition fault :
P2452-0F
is coming back, i don't have to start engine.