CRAFTER EDC16CP34 software help needed

[massiwe]

Hello everybody
I have read whole ECU via BDM port in CMD BDM advanced mode. Later updated FLASH with DPF off and writed one back into the ECU. Since this moment the car is not starting anymore and I have no comm with the ECU.
So, please anyone who have complete readout of such ECU via BDM to help me with the good file.
I can use one in CMD BDM or EVC BdmToGo format.
Thanx in advance

[massiwe]

The ECU info:
EDC16CP34 4,4
0281014132
074 906 032 BA

[786mo]

Post your original readout with CMD please.

[massiwe]

Right now I can't reach my files, I'll post'em on sunday.

[icezero2010]

i have only this i hope its help

[ominimicu]

Ori looks fine. Flash back Ori and eeprom(in cse of rolling code change) via BDM

[massiwe]

I'm back.
Here are my ori files from the first readout.
They are read one by one in advanced mode.
after writing FLASH with DPF off - ECU lost comm
then I've rewrited ori FLASH and still no comm
then next try was all three ori files one by one and no comm
Right now I'm confused. Is that ECU by software games appear to be defect or it is still something wrong with CRC?
Thats why I'm looking for complete readout in one file just to be sure if ECU is still alive.

Tools I have:
CMD Master BDM tool
EVC BDM to Go

[massiwe]

To ICEZERO2010
Thans for reply, but you have FLASH and EEPROM only.
This ECU have three memories which are together calculated with checksum.
I'm missing CPU as well.

To everybody
I've heard rumours that CMD in advanced mode is adding to read memory something extra, like own informations about interface or file.
If so, then probably my files are OK till the checksum reach this new data.

[ominimicu]

Files are good mate...checksum is OK, i think you might have damaged ecu...while connecting BDM..
have you already tried to write original flash AND EEPROM?

[massiwe]

Yes I tried to write back ori files one by one and still no comm.
But it is quite strange for my that this ECU went wrong by connecting to BDM.
I could understand problems with BDM comm and processor itself but not with the part which is connected to outside.
I'll try to replace integrated supply and comm chip others I need to find other ECU.

[elephantul]

i have once this probleme with crafter, read with bdm, put modified file, not start, put again original file,not start, only if calculate cks with bdm after writing (is a buton in soft ) car start with both files,

[massiwe]

Yes, you are right, the cks button works. Now I have only P00000 still to fix after DPF OFF.