Golf IV edc 15 inmo off ,Uce blocked

[ligno1]

Hi folks, I need a ring inmo Iv tdi golf ahf, failed a few times but now will not start with any key, inmo light flashes whenever I tried vagk + 1.4 and 2.5 but can not read eeprom inmo uce to override.
and solve this problem?, give me ideas, programmer, carprog?
greetings, thanks


vcds says error: (motor control unit blocked dwe)


Chassis Type: 1J - VW Golf / Bora IV
Scan: 01 02 03 08 15 16 17 19 22 29 35 36 37 39 46 47 55 56 57 75
76

Mileage: 165660km/102936miles
-------------------------------------------------- -----------------------------
Address 01: Engine Labels: 038-906-018-AGR.lbl
Part No: 038 906 018 BM
Component: 1,9 l R4 EDC 2115 G000AG
Coding: 00001
Shop #: WSC 00011
VCID: 62C1B451EE54909


1 Fault Found:
17978 - Engine Start Blocked by Immobilizer
P1570 - 35-00 -
Readiness: N / A

[ominimicu]

it happends..you need to read eeprom witha programer, desolder from ecu

[arvedo]

read eproms and post here

[ligno1]

Ok , that I look and read eeprom? 95,93,24, and for reading best desoldering to use clip?
thanks

[ominimicu]

tell me exact ecu or ecu numbers,,sometiems iot can be done via flash...depends on ecu

[ligno1]

This is the numbering

https://www.dropbox.com/s/ii2f3wzq0edqk95/DSC02586.JPG

211212211213211214

[haci1978]

Would you write the number on the chip to read for example 24c02 95320 95160

[ominimicu]

EEPROM is a 24C02 with any of these masks

MASK: B58253
MASK: B58258
MASK: B58383
MASK: B57669
MASK: B58293

[ligno1]

Any help is appreciated, keep in mind that this work will need for my (I'm lying without a car) I do not do these things (this course) but I would like to try to fix it myself (with your help),some image, pattern, etc. type of programmer?

thanks

[ominimicu]

I just posted info! any programmer that can read 24C02 will do

[fruti]

Take this ecu to someone who is expert in that kind of stuff and he will help you ..... i'm sure it wont be expensive!
If you do that for first time you can do more damage.
I'm not an mason so i don't build houses by myself but leave that to proffesionals!
:) No offence.

[ligno1]

Take this ecu to someone who is expert in that kind of stuff and he will help you ..... i'm sure it wont be expensive!
If you do that for first time you can do more damage.
I'm not an mason so i don't build houses by myself but leave that to proffesionals!
:) No offence.

None taken, as the professional I agree (though close to where I live there is anyone), but I need the car to go to work on Monday, so I wanted to solve then and now

Thanks for your help (I have seen on the plate B58253, try to read com 24c02 unsuccessfully, I have no hot air to remove, I sulucionado (for now) with vag tacho2.5 marrying the two keys, after many attempts, it works ,


thank you very much

[fruti]

Cheers mate!