cas4 bmw f10

[ION CRISTI]

guys i try change mileage from bmw series 5 f10, year 2010 with tool enigma and the cas dead.
the cas is proc motorola 9s12xdp512 1L15 mask. i put diagnose from this car and comunication with cas but car not start, not ignition on. is any solution from this cas?

[rukartinatv]

Cas remain in programer mode.
did you change the km in cas4 put back and car dead right?
post you dump from cas4 i will check.

[ION CRISTI]

yes that right. i put tommorow the backup dump from cass4. thanks very much

[ION CRISTI]

here is the dump the cas4

[bersch8688]

The File it?s ok

213481

[ION CRISTI]

is possible the flash cas is corupt

[markony79]

here is the dump the cas4

try this
repair file with 0km

pass in your pm

[ION CRISTI]

not work. same error.

[wiseman]

Look on the cas PCB for solder bridging. You may have a short somewhere, could be tiny but stop it from functioning

[rukartinatv]

yes i checked your dump look ok.
check solder in the cas4

[Alexuko]

And if not, unsolder the chip and> ETL. Check flash

[rukartinatv]

Dont unsolder nothing !!!!

[XmoDDeR]

Dont unsolder nothing !!!!


Might be tooo late ....... :blue:

[markony79]

check with this second file

if not work, post your cas nr

pass is the same

[Speedosoft]

Enigma does not work good with 1L15Y when reset pin is not lifted. Sometimes it even reads a wrong mileage. Lift up reset and attach the wire to it directly next time. R270 works just perfectly. If you can't hear the car wake up or the push button does not light when you plug all the 2 or 3 connectors (on CAS), chances are the flash is corrupted. If there are no solder bridges and no flash problem, you might want to order a new CAS at this point.

[detayoto]

Greetings. I have been using for a long time and BMW CAS 4 enigma tool did at least 20 times.
enigma of a failure in this model works very well and is very difficult to
I have a soldering fault in your cas
need to remove the reset pin. Are you sure you use the right cable?

[Rito]

I think problem is flash...Best away to resolve it, is use Rosfar R260 red tool, and use Recovery tool for write new Flash...
Someone have flash for it?post here for help our friend.... (i not have for this cas4)