Peugeot 307 MC68HC912 PIN and replace BSI

[danihaos]

Hello! I have a Peugeot 307 with broken Bsi Valeo inside MC68HC912 read with UPA,EEPROM and all memory. I want the PIN . I have found another good BSI but I need somewone to tell me if what I read is good or damage and what the best solution for this,put all memory dump in new BSI or make virgin and program with Planet.Thank's in advance!

[Shmortz]

you don't need to replace BSI, just reprogram it using VIB and PIN for the car, they are erased in that eeprom, I see only 223357km in eeprom dump, this is common failure in that type of BSI, happend when battery have battery problems... if you don't have pin read ECU eeprom and post here...

[danihaos]

Do I need virgin BSI and if so you can do it for me?

[danihaos]

I read with UPA as 8bit eeprom 93C56 from ECU pin is UKP8?

[kona4]

hi
your DME is 7.4.4 ?
you can Read 29F400 in DME ?

[danihaos]

hi
your DME is 7.4.4 ?
you can Read 29F400 in DME ?
Sorry I don't have tool to read 29F400.

[gwee]

I have same car same ECU. Try to communicate ECU with Peugeot Planet but no reply from ECU.

Maybe someone can give me the virgin dump for 29F400 and 93c56.

Please advise.

Thanks.

[Shmortz]

I read with UPA as 8bit eeprom 93C56 from ECU pin is UKP8?

this is SID801, pin is 8PKU or P8UK

[danihaos]

you don't need to replace BSI, just reprogram it using VIB and PIN for the car, they are erased in that eeprom, I see only 223357km in eeprom dump, this is common failure in that type of BSI, happend when battery have battery problems... if you don't have pin read ECU eeprom and post here...
I have try to reprogam the original bsi but no communication with planet.Put another bsi with original dump(what is left from it) I program the VIN and pin KU8P but when I try to write the old key no joy. In diagnostic shows 0 keys and unit locked. What i have to do next ? Any advice is helpful. Thanks.

[danihaos]

Today I try to program old key after entering pin found in ECU the Planet diagnostic want the number of keys(i have just one) and tells me to unlock the car and remove the key No 1 ; put the key number 1 inside ; learning and after that it tells me to check of programming of key number 1 What it means because if I wait it stays forever at checking procedure and if I push OK button it skip the checking procedure and wants to learning one more time but unsuccessful. What i have do wrong?

[danihaos]

Problem solved. IMMO off.