PDA

View Full Version : Suzuki Baleno 1.3 33920-60GR0



mellon
19th August, 2013, 04:59 PM
Hi, I need immo off in Suzuki Baleno 1.3
33920-60GR0
33920-60G9
Denso
eprom: TC97101P

Best regards
Adam

Listek22
20th August, 2013, 03:04 AM
Remove eeprom and you should have no immo.

mellon
20th August, 2013, 07:34 AM
Ok. Do I have to remove immo box?

Listek22
20th August, 2013, 07:46 AM
As usual- yes.

mellon
20th August, 2013, 08:54 AM
but not working without eprom

Listek22
20th August, 2013, 09:08 AM
Ok, so there's 2 things you can try: 1- the same but with immobox 2- write eeprom with ff and try with and without immo

mellon
20th August, 2013, 02:48 PM
Without immobox and eprom fill by FF car start for 3sec and I have to reconect ecu than start again. When check lamp stay on car run after stop check lamp blinking.

RhinomanUK
22nd August, 2013, 09:27 PM
What tool are you using to programme the TC97101?

mellon
23rd August, 2013, 09:11 AM
What tool are you using to programme the TC97101?
SEEprog by elnec

mellon
23rd August, 2013, 10:34 AM
I have one key:
7E CF C2 7A 00 00 00 00 00 0E 85 7E 00 00

I think that ecu eprom is corrupt or immobox fail becuse.

Anmed
23rd August, 2013, 11:24 AM
I think that ecu eprom is bad! Donor need. If you want only start car - try 1k resistor between 4 and 8 pin 97101(remove).

mellon
23rd August, 2013, 12:41 PM
works! Thank very very much Anmed!