Vw golf r32 Bosch ME 7.1.1 with galleto 2

[javyb]

Can anyone confirm if Galletto 2 china clone can read & write this ecu by OBD without problems if checksum is corrected before write cheers

[Babos]

about china clone i have few report with ME7.xx after reading ECU enable protection and after need mod flash and eeprom!
for this car must beter need use MPPS.
Best regards.

[carmageddon]

my experience : mpps readout ok, write back simple mod for lambda off and block ecu, tested 4 times via obd and 4 times block.

kess1, kess2, cmd, fgtech 48 and 53/54 work without problem.

[javyb]

I have galletto v51?

[OVERSPEED]

Chinese FGtech not work well on mostly ME7 (To be honest in many other ECUs too lol !)

[wiseman]

On me7.1 only tool I've really had success with Obd is powergate M

[J_amb_o]

Byteshooter and genuine MPPS

[javyb]

What about genuine kess v2 slave?

[veloseeped]

Some R32 ME7.1.1 use CAN, not K-line r/w protocol.
MPPS will not work.
Use original CMD or Byteshooter
Using G2 clone is on your own risk.

[chriskross]

Me 7.5 is working well with galletto 2 eu clone i made yesterday one

[javyb]

so safer to read ECU out of car in boot mode with galetto then?

[OVERSPEED]

Mine Euroclone read OK, but fails Writing ME7.5 With 1.024K... it can read and write OK ME7.5 with 512K.

[javyb]

Mine Euroclone read OK, but fails Writing ME7.5 With 1.024K... it can read and write OK ME7.5 with 512K.

How to tell if its 1024 or 512k

[OVERSPEED]

Read it ... they both Work Ok for reading, only Writing 1.024Kb models will have issue (it stop at about 10~15% give error and will only write again in bootmode)