xdamdamx
24th August, 2013, 05:25 PM
Hello all!
If you have problems with starting engine after accident, do the following:
1. remove airbag ECU and reset it.
2. re-install into car
3. connect CLIP and make a full scan
4. connect to [120] - engine ECU
5. Read DTC's
6. Even if there are no errors - Clear DTC's
7. Disconnect battery for a minute
8. Reconnect batt. and that's it.
Hope it helps. If you only want to start the engine, you don't have to reinstall airbag ecu, just leave it disconnected.
If you made use of this info-> click thanks :)
If you have problems with starting engine after accident, do the following:
1. remove airbag ECU and reset it.
2. re-install into car
3. connect CLIP and make a full scan
4. connect to [120] - engine ECU
5. Read DTC's
6. Even if there are no errors - Clear DTC's
7. Disconnect battery for a minute
8. Reconnect batt. and that's it.
Hope it helps. If you only want to start the engine, you don't have to reinstall airbag ecu, just leave it disconnected.
If you made use of this info-> click thanks :)