PDA

View Full Version : boot pin bmw edc17



jordiksvk
4th September, 2013, 05:18 PM
where is boot pin on this board?
wery similar than edc17cp09
thanx

ernesto90
4th September, 2013, 05:39 PM
M2 PIN 8 +12V
M2 PIN 3 GND
M3 PIN 20 CAN H
M3 PIN 19 CAN L
M3 PIN 13 +12V
I include photos boot

ernesto90
4th September, 2013, 05:43 PM
................................

jordiksvk
4th September, 2013, 06:12 PM
thanx but it is not mine board
look at the coil and the capacitors near
are different orientation,
and i havent theses points like your picture

ernesto90
4th September, 2013, 06:18 PM
give me number HW control unit please

jordiksvk
4th September, 2013, 06:54 PM
here is the ticket attached from ecu....

ernesto90
4th September, 2013, 07:08 PM
I'm sorry I have no solution for this.

mihaiservice
5th September, 2013, 11:34 AM
Hi
upload picture with mcu tricore !!

Mike

filecloud
5th September, 2013, 12:48 PM
EDC17C41
Bootpin and processor are on the bottom of the board!

jordiksvk
9th September, 2013, 02:06 PM
the board will be glued, and will stich hard at bottom side?
its risc to split it?
need to hot it or some other hint ?
thx

filecloud
9th September, 2013, 03:24 PM
Yes, there is a risk to kill the board. Please go to a tuner that has already done this and ask him if you can watch his work.

pulsar2000
20th September, 2015, 10:26 AM
there is a magpro tool where it drills a hole in outer casing, in exact location,
had this same ecu the other day, was disspointed to see that you need to seperate both cases of metal to obtain boot,
i cant see that you can split without damage, i used allot of HEAT !! and could see and hear board stressing,
so i put back together to send customer to someone else to BREAK / TUNE :> ecu,