NISSAN QASHQAI 2,0 DCI don`t START,after GALLETTO 2

[wadim21]

after reflash car not start,i write back orig. flash and car again not start.I have 2 DTC ( 1. INCORRECT inj CODES AAAAAA) and error immo P1612.I try BOSCH KTS and launch DIAGUN can`t make recode injector.Need help .

[ominimicu]

u sure your Ori file is OK? with ori file you should be able to reprogram inj codes

[wadim21]

yes i think flash work.problem EEPROM.

[chipauto]

Problem in flach
Eeproom good
Read file full bdm

[wadim21]

ok. full bdm

[assitutto]

car have lost injector coding, recode injector with diag and it should start
i have the same problem in nissan xtrail and i have recode injector with brain bee st9000

[wadim21]

it possible with nissan consult?

[adusia123]

write eeprom

test

218564

[shadow12]

for me nissan consult didnt work, had to get dealer to recode injectors

[wadim21]

to adusa ,now i have one DTC P 1611 nats fault.i think lost synchro with BCM

[wadim21]

problem solved. I made new key for synchro ECU BCM

[mexanico1971]

HI !
any one have the pin out for this ecu !
is one bosh and it have 3 plugs !

[wadim21]

I recode injectors with CLIP and ECU from Renault 2.DCI,.
1. connect Clip to ECU
2.recode injectors
3, read eeprom ECU Renault
4,copy 4 strings from Renault to Nissan ECU EEPROM.(00E0 00F0 0100 0110)
Work perfect

[mexanico1971]

So I can use can clip to reset ecu in nissan qashqai ?!
because I have p1435 that"s don"t go out !

regards

[wadim21]

don"t go out

with nissan consult?

[mexanico1971]

no !
reanult can clip !

[gttuning]

just small info.i use galletto2 can coder under renault, this will read your inj.coding.after u upload tuned file up load this file with inj.coding and car stars ok.