elcarpuz
13th September, 2013, 06:28 PM
Last month i do chiptuning on ecu, unsolder plcc32, reprog and resolder...
when replug, engine start and stop after 20 seconds, i restart and engine stop after 10 seconds, after impossible to restart
reopen ecu unsolder, resolder 3 or 4 times for retest with chiptuned and ORI, same problem....
on diag no communication
i have hound anorher second hand ecu, test and start well
open unsolder program and resold, and again same problem, stop automatically, restart 2 or 3 times and after nothing, diag no communication
please idea?
Do you think ot?s better tosolder plcc socket? I'm affraid with socket for wrong contact
I have tested new eprom and always same problem
Solder are with hot air, iron and flux
when replug, engine start and stop after 20 seconds, i restart and engine stop after 10 seconds, after impossible to restart
reopen ecu unsolder, resolder 3 or 4 times for retest with chiptuned and ORI, same problem....
on diag no communication
i have hound anorher second hand ecu, test and start well
open unsolder program and resold, and again same problem, stop automatically, restart 2 or 3 times and after nothing, diag no communication
please idea?
Do you think ot?s better tosolder plcc socket? I'm affraid with socket for wrong contact
I have tested new eprom and always same problem
Solder are with hot air, iron and flux