View Full Version : E60 ecu broken help clone not possible
dariobmw
23rd September, 2013, 10:31 AM
Please i need help with this ecu broken from BMW e60 525d .
The original ecu is dead , but i read with BDM and i tryed to
clone but without success (no live data and no communication
with car sistems but yes diag and serial number read only).
Please help with immo IF possible to pass from old broken
to new (scrap) ecu.
I see some posts with ISN tricks , but im somekind retard in
front of that .
THANKS220779
xdamdamx
23rd September, 2013, 10:44 AM
Read 9s12 from CAS, read BDM from new/used/ ECU ,and post them all. I'll rewrite ISN from your ECU to CAS. Then re-align CAS->DDE and go on.
dariobmw
23rd September, 2013, 11:13 AM
Big thaks for interest but i **** read the cas from the car because is not on my garage , is a possibility you kan make
a immo data transplant from old to new ecu ?
Is important to me because the car i is not on my garage and is toooo far fro me
THAKS ALOT
AlexandruP
23rd September, 2013, 12:11 PM
I make ISN for you but can't upload, can you give email then I send you?
AlexandruP
23rd September, 2013, 03:19 PM
Check mail pls
dariobmw
23rd September, 2013, 06:51 PM
thanks for help to alexandrup
BIG THANKS !!!!
dimitar
24th September, 2013, 09:46 PM
Dont bother with CAS just transfer eeprom from old to new ecu works 100% tested several times in many bmw edc16 ecus
keep the original flash and mpc from one ecu, dont mix them up you will end up with no fault codes and car not starting.....strange doesn it
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.