View Full Version : Polo 1.6 16v 2001 , where is the pin code
eric paris
25th September, 2013, 09:38 PM
hello,
do you know the solution to find the code pin for program a new key ?
is it in the immobox or ine the ecu ?
thanks
eric
haroutioun
26th September, 2013, 05:49 AM
hello,
do you know the solution to find the code pin for program a new key ?
is it in the immobox or ine the ecu ?
thanks
eric
Hi.
in immobox
Mr BLACK
26th September, 2013, 12:38 PM
i do not know for sure .....but at this model immo is in dash board
eric paris
26th September, 2013, 08:08 PM
hello,
thanks , l have immo box
it's easy to read the pin code ?
kugglefischer
26th September, 2013, 08:10 PM
yup....
in immo box..
newer ones were in dash.....
eric paris
10th October, 2013, 05:45 PM
hello,
l take a picture , do you know witch circuit l must read to find the pin code ?
tanks
eric
223903
Carkeysa
10th October, 2013, 09:18 PM
hello,
l take a picture , do you know witch circuit l must read to find the pin code ?
tanks
eric
223903
I did one recently and found the pin code on the immo box label below the barcode, it was covered with black tape which peeled off.
rm23
10th October, 2013, 11:26 PM
try to read eeprom 24c04
electrones
10th October, 2013, 11:46 PM
try to read eeprom 24c04
Correct
Take a look
JOHNCICY
18th October, 2013, 08:18 AM
Hi i need eprom dump and ecu dump for ths polo with magneti marelli ecu 95040 and immo VALEO 24c04 working dumps both in ecu and immo.THANKS
eric paris
10th November, 2013, 02:59 PM
hello,
in the immobox l desolde and read the 24c04
can you find the pin code ?
many thanks
ruffles1986
10th November, 2013, 03:04 PM
Pin code is 01072
eric paris
10th November, 2013, 03:51 PM
thanks
you have a soft to find it ?
yellowstilo
10th November, 2013, 04:54 PM
you don't need soft , just Brain.exe - look on locations 66-67 + 112-113 + 1BE-1BF > 30 04 > swap bytes > 04 30 hex = 1072 decimal > add 0 > your pin is 01072....
eric paris
10th November, 2013, 05:04 PM
thanks for the lesson , l like learning :-)
yellowstilo
10th November, 2013, 05:50 PM
thanks for the lesson , l like learning :-)
me too, that's why i like DK so much....
Carkeysa
27th June, 2015, 09:04 AM
I've used the above file in a damaged chip 24c04 and put it into the immo box and programmed a chip. Do I need to do any other matching to my vehicle or will it start the vehicle? Vehicle is not close to me so I would appreciate any advice. Thanks in advance.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.