telveskid
26th September, 2013, 08:54 PM
hi guys,
i hoping to set up my motorised system again after moving house.
got a 1 metre dish & Technomate TM1500 & Fortecstar Motor.
Am hoping to do it like (once dish fitted to motor) and everything is spot on using spirit level.
Manually move motor & dish until i find 1 west with Sat bleeper than manually move dish East and store Satellites using Disqec Method
OR can i change to usuals on TM1500 Reciever and enter my lattitude & Longittude
eg LAT = 53.2797N (rounded off to 53.3)
long = -2.8999W (rounded off to 2.9 W)
And let the motor find each one in turn(Can i change back to Discqec Afterwards)
Any help appreciated am a bit rusty on this
Kindest Regards
i hoping to set up my motorised system again after moving house.
got a 1 metre dish & Technomate TM1500 & Fortecstar Motor.
Am hoping to do it like (once dish fitted to motor) and everything is spot on using spirit level.
Manually move motor & dish until i find 1 west with Sat bleeper than manually move dish East and store Satellites using Disqec Method
OR can i change to usuals on TM1500 Reciever and enter my lattitude & Longittude
eg LAT = 53.2797N (rounded off to 53.3)
long = -2.8999W (rounded off to 2.9 W)
And let the motor find each one in turn(Can i change back to Discqec Afterwards)
Any help appreciated am a bit rusty on this
Kindest Regards