vectra 2008 access denied help!!

[nazz2]

Hi
This car has given me head ache, It is 2008 vauxhall vectra, 1.9 diesel, pulled the pin with Adpro, vin checks with ad, also got the pin from vauxhall, which is the same but still the dreaded access denied, disconnected the car bat, same, left ignition on for 1 hour ,still cant get in.

Can anyone suggests a way to get in the system?This is a lost key situation, Thanks inadvance.

[autosocket]

Reset and program cim with code you got. If this is possible then your codes correct.

[keygargoil]

read the 93c66 from the clocks ad will pull it from the radio or center display if it has been changed it will not work

[ninja123]

also check in live readings that security wait time is not active, if active, you will need to leave ignition on for the time period stated then try again. If engine ecu is edc16c39 then you cant read pincode from that either, if other then carprog and smok can read from ecu.

ninja

[nazz2]

Thanks gents for all the suggestions, once i left the ignition on for one hour, still no go, I was going keygargoil way, was not sure where the pin is stored on these, in the cim unit, I found 93c76, but nothing support this module. Managed to get someone to come and give me a hand with tech2 on wednesday, will post results . Just incase anyone knows where in the clocks the eeprom is located? Thanks.

[ninja123]

strip clocks down and you will find eeprom, read and pin is visible in the ASCII near the bottom of dump.

ninja

[nazz2]

Thanks matey, lets see what tech2 will do on wednesday, then i go that route, bloody Taxi!

[nazz2]

Its all sorted, At the end pulled the pin with AD100 pro, and programmed with original vagtacho!!, i think it must have been the ignition switch, since the key got programmed in without turning the ignition on.!!