freelander 0281010113 immo off

[atomiczen]

i'm trying to make a immo off on a freelander year 2000 diesel with a bosch 0281010113 ecu msa 11
immo decoding tell me to program both 93c46 eeprom and disconnect the immo box and splice togheter yellow and black wire

where's immobox on this car!?!?!?

please help me!

[Shmortz]

I think in this car immo is incorporated in body control module, can't be removed separetly... just need to cut immo line and connect black/yellow wire from starter relay to GND...

[atomiczen]

I think in this car immo is incorporated in body control module, can't be removed separetly... just need to cut immo line and connect black/yellow wire from starter relay to GND...
hi shmortz, i have ear that it's possible to immo off this car switching the 2 dil for 50 seconds with ign on or removing one of the 93c46
immo dec 3.2 tell me to program both 93c46 remove trasponder and splice togheter yellow and black wire, info isn't too clear....where are these yellow and black wires???

i have to cut immo line from ecu or from body computer?
antenna must be connected or not? there's 2 antenna on this car, one over the dash for the remote control, and one ring into the ignition switch
where's starter relay?

please help me because i become crazy with this car

[atomiczen]

for who need i have found a solution here on forum
remove the 93c46 near the yellow capacitors then cut pin 45 to the ecu

tomorrow i'll test and report

[atomiczen]

for who need i have found a solution here on forum
remove the 93c46 near the yellow capacitors then cut pin 45 to the ecu

tomorrow i'll test and report
this solution don't work for me, car don't start

[atomiczen]

problem solved, thanks to stoyanov and shmortz, problem was mine, i forgot to connect black/yellow wire from relay to ground
dk forum is everytime the right solution!

[ssemmedo]

thanks for sharing. i?ll post result soonly.

[ssemmedo]

please e need one more help. i need pinout to know pin 45 and i need to know the location of the starter relay. regards

[Tonkov]

488353488355

[wolfoyo]

i try this solution today

[Tonkov]

Immo off ecu msa 11


1.Remove the 93c46 near the yellow capacitors.
2.Cut pin 45 to the ecu.
3.Connect black/yellow wire from starter relay to ground.

[CaioW]

Immo off ecu msa 11


1.Remove the 93c46 near the yellow capacitors.
2.Cut pin 45 to the ecu.
3.Connect black/yellow wire from starter relay to ground.

Works like a charm.

Thanks buddie

[ugur028]

ben yapamadım tam olarak epromu sökmelimiyim bana detaylı yaprdımcı olurmusunuz

[rafal]

ben yapamadım tam olarak epromu sökmelimiyim bana detaylı yaprdımcı olurmusunuz

this forum is using ONLY english language

anyway from 2016 really not very helpfull

[tibibond]

hello guys. i need help locating the black/yellow wire from starting relay. could you please tell me where is located? thank you

[rafal]

hello guys. i need help locating the black/yellow wire from starting relay. could you please tell me where is located? thank you

relay is under bonnet on the left side of car

[Darekhiszp]

Hi, I need to know where is pin nr 45 in conector ?

[dragoshu]

Hello,
I have same situation on freelander 98 cut pin 45 and remuve eeprom ,problem it that on relay i dond have yello and blak cable.
I have 3 cable 2mm tick and one black and pink 1,5mm tick
I have put pin short to grd of battery and after I connect+ to car alarm start to ON and car dont crank
Any solution for this or advice
thanks
dragoshu

[rafal]

have a look on diagram of relay................then you will know how to connect

[031 ecu repairs]

howsit atomic do i take the chip off and leave it off please let me know thanks

[mrjackkilby]

Immo off ecu msa 11


1.Remove the 93c46 near the yellow capacitors.
2.Cut pin 45 to the ecu.
3.Connect black/yellow wire from starter relay to ground.is it only removed, or must it be programmed with uid 3.2?

Sent from my SM-A715F using Tapatalk

[eastern]

try to count :) BOSCH ECU has 55 pins, first row from 1 to 19, second row from 20 to 37 and the third from 38 to 55. So pin 45 is the 8th from the bottom right if you look at the connector from outside.

[Ladis]

Zde je uvedeno, co je třeba na eepromu změnit a co se připojit, nikoli trvale odstranit eeprom

[Alexsei]

Почему нельзя просто удалить?

[Alexsei]

Ребята так работает иммо оф так?

[Alexsei]

при удаление,работает стабильно?

[risco23]

Hello guys. Could you please help me? I do all what you wrote. Car is starting but central locking not working. Opening just drivers door and if i want to open hood then car start alarm.... What is wrong please? Thank you.