mercedes atego ecu problem

[cartech]

hello!
I have mercedes Atego year 2006 with burned ecu (full ecu burned , eeprom too), I have second hand ecu!
how program it with das?
it need to virgin it?
wich tool to do that?
please help me

[zoyzoyni]

plug in to the car read eep and syncronise key.thats all.

[cartech]

plug in to the car read eep and syncronise key.thats all.

I have tryed , but das demand vedoc code
from where get it???

[treo]

Read eeprom and make new key.

[cartech]

thanks, but make new key from ecu (not original) and FR is original have original transponder, will work normally?

[zoyzoyni]

read 93c66 and make new key.or post for virgin.

[king alie]

hello
the transponder key is just for the MR

the FR just send the transponder key data to the MR and ll not disable the mr if the key is correct

[cartech]

thank u for all!
now I have installed ecu and programmed transponder , but engine not cranck
what's up?

[bursuc]

do you read actual values parrameters? where is not recognized the key ?

go with das and real immobiliser parrameters and post here .

regards

[zoyzoyni]

did you write dump in T5 transporter?

[cartech]

hello!
sorry for a delay
I have installed other ecu , now car start from starter block, not from key ignition????
why engine not cranck from ignition key?
I'm waiting your help

[cartech]

Im waiting some helps!
thanks

[cartech]

please answer me why engine not cranck from key lock ignition?
but if power on starter, car start
please who can help me for this end step????
thanks in advanced

[massiwe]

First. Don't crank direct on starter, this way you're asking for next burned ECU if already is not burned.
Second. Building year of this Atego? As I remember with or without right transponder engine should crank from ignition. Not learned key is blocking pumps but engine should turn. Check the connections and voltage when kl50 is on. Check the actual values in PLD kl15, kl50, CAN with FR.
Third. You say: if you put power on starter, car starts? or engine just turns?
Fourth. Do you work with Star Diagnosis?
Just try to give us clear information otherwise we can't help u.

[cartech]

First. Don't crank direct on starter, this way you're asking for next burned ECU if already is not burned.
Second. Building year of this Atego? As ......
First: Im installed second ecu (ecu bought from second hand)
second: year atego 2006, now truck far I can't check actual value in pld.....
third:yes when I puted power on starter, truck start and I have drive it to other place (moved)!!!
fourth:yes I work with star diagnostics.
hope u can help me





226943
226945

[cartech]

any experts there????

[Bazil_mb]

Hi.
If the truck start dicectly , you must ceck in actual value starting value. look on control module adaptation if option mr working together with fr is yes. If is no truck start with butons ( on left side of engine). In worst case you have a driver burn in mr ecu( actuation of starter) Ceck on small plug if starter signal goes out.Atego have a lot of problems with cable: under engine, near generator and near starter.In my opinion you have a wire corroded and with hig resistence.
Regards
Bazil

[contatosaulo]

ola voce pode me ajudar com um atego?

[Camaleon]

thanks my fryend god night i have a problem =