iaw 5nf T2

[antwnhszr]

hello m8's.i have one ecu from fiat doblo IAW 5NF T2. i want to take the dump from eeprom (95160) and the dump from the ST mcu.
i need pinout's from this ecu . i have mpps europe cable. someone guy know how to connect on the ecu with this cable?
regard's

[elephantul]

for read 95160 with upa this connection is tested in many ecu by my, dont need to read st, work only cloning 95160

[antwnhszr]

for read 95160 with upa this connection is tested in many ecu by my, dont need to read st, work only cloning 95160

thank you my dear friend elephantul but i need read the st because must transfer the dump from 5nf t2 to 5nf t1.....
reagrd's

[elephantul]

not need ,work good without transfer st

[antwnhszr]

i desolder all the pcb and read the eeprom because when read with the upa under the connection's of this foto the upa in the verify operation appear many error's
regard's

[kevfield]

Look in my uploads there is photo how and where to drill hole in other side to remove eeprom so no need to remove PCB......

Thanks kev