PDA

View Full Version : Abit IP35 pro XE



jimbo1951
13th May, 2009, 05:55 PM
Hi all
Just built a new rig with the above motherboard in it, and corsair dominator memory modules, because of problems with the first modules have ended up with 8mb, however, cannot get 8 to run, any two of the modules together are fine, but when all four are fitted it fails at C1 in the post sequence which is the memory detect bit.
Can anyone give us a clue as the old grey matter has gone blank !

Thanks

chroma
13th May, 2009, 11:32 PM
wrong forum.

that being said, try two, turn of serial presence detect (SPD) and manualy set up your ram.

if that still fails then it points to a compatability issue between the memory and your north bridge. a bios update may resolve this (check on the manufacturers site)