rover 200 immo off

[eng_mike]

Hi,

The motor unit ECU is
Bosh 0 281 001 418
type 4108
MSB100491

eprom 93c46 inside,
i read it like 8bit and 16bit...

please make immo off in dumps, and tell wich wire/wires I need to cut or make shunt....

BR

227709
227710

[ruffles1986]

Try this and report

[key4man]

hi


Program the EEPROM 93C46 Right and Left

Remove the control unit of the transponder
Jumper the two wires black yellow

[eng_mike]

Hi,

Wich eprom are right and left? I only see 93c46....

Can you send photo?
And...
did you have photo of the plug wire to see the pin numbers I need to jump...
And... The immo box still disconected for ever?

BR....




hi


Program the EEPROM 93C46 Right and Left

Remove the control unit of the transponder
Jumper the two wires black yellow

[eng_mike]

Hi,

Now I see there are two eprom.... I dont know wich are you telling is right and who is left, but you only sent one bin, so, I think I need to write the same bin on the two eprom, right?

and in the ecu, I dont need to cut any pin?

Only jump the wires you said?

Br

[key4man]

hi
program the 2 eprom

[eng_mike]

Hi,

My ECU is not MSA..... is MSB100491, you can see on attach...

Did you test this? the same file in the two dumps?

And dont need to cut any wire, or short to conect starter relay?

BR

[key4man]

hi

Sorry my mistake, I did not notice the type of u ecu, anyway try this dump,

227880
Perhaps this picture can help

[eng_mike]

Hi,

See the picture, my ECU have two 93c46...

And this plug on the first line of wires, dont have wire on PIN1...

So, if you have schematic to I see what to cut and jump on this car, please sent... (like cut wire led on dash, cut wire beep on car, cut wire alarm... and wire I need to connect to turn on starter relay...

BR

[key4man]

hi
228048

[eprombyxim]

Quit 2 eeprom in the mother board and cut immo line???? the car start???

[eng_mike]

hi
228048
Many thanks....

SOLVED!



Quit 2 eeprom in the mother board and cut immo line???? the car start???

Hi,

The car only start when I put the Starter relay wire to GND....
then, after,,,,

I Cut immo led wire
I cut buzzer wire
I cut alarm wire...

And now car start, door automatic lock work,,,,

everything is OK now...

BR