matias
7th November, 2013, 03:42 PM
Hi all,
I have question. I have original x-prog m. And to version 4.8. work tool for dashboard with micronas fine. After install new wersion and install ew firmware to xprog I can only read, write micronas and eeprom, but when I need use button tool for change values. I have only message idle, or read incorrectly.
Who have the same problem. Have U any solution for this. I have new wires connector and wires. I sent info about this Darius.
BR
Matias
I have question. I have original x-prog m. And to version 4.8. work tool for dashboard with micronas fine. After install new wersion and install ew firmware to xprog I can only read, write micronas and eeprom, but when I need use button tool for change values. I have only message idle, or read incorrectly.
Who have the same problem. Have U any solution for this. I have new wires connector and wires. I sent info about this Darius.
BR
Matias