View Full Version : dash opel in the table
newgeniehex
8th November, 2013, 08:46 AM
hello
it is possible to change the mileage whit open the dash via k line
i have tacho universal but i don't have the menu agila
the algo it is same opel corsa?????
i have digiprog 4.82 it is possible to change the mileage on the table whit this tool?
pinout by nyo 4
12V= pin 2 and 17
GND=1
k-line=14
many thank in advance regard
konq100
8th November, 2013, 10:28 AM
No, you need to open and use Digi with ST 59. Inside is nec processor.
See the procedure in Digi manual.
bersch8688
8th November, 2013, 10:48 AM
look here you need ST59
228831
newgeniehex
8th November, 2013, 07:34 PM
hello
thank to all
it is possible to change the mileage whitout open the dask via k line???
i don't have the ST59 in my packtge digiprog!!! and is very difficult to connect the wire in the processor nec
opcom can do via obd or dash connector?????
regard
vasa
8th November, 2013, 09:18 PM
HI is posible make via K-line but i dont know whit DIGIprog
km666
8th November, 2013, 10:00 PM
Use Op-Com!OP-com write km via k-line!
honingkoning
8th November, 2013, 10:28 PM
Op com is ok for this dash.
Connections are on dk, i post them earlier.
Wbr
newgeniehex
9th November, 2013, 10:54 AM
hello
thank to all
regard
someone777
6th August, 2017, 08:09 PM
Hi i need dump from this tacho. Can you help?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.