Nissan Navara 2012 Help

[Speedofix]

I have open dash and try this is not like the PDF 843 in my DP3. Anyone have other dpf's for 2012 Navara ?
Costumer have take car back again so need more info before car get's back.

[kokorocato]

that's what you want? I have a pin connection upa

[rukartinatv]

Post you photo of the dash.

[kokorocato]

this is for upa

[Speedofix]

That PI is from 2006- up Navara.. Ithink It's about 3 different dash after 2010- ?

[teerak2uk]

Here you go

229164

[88diablo]

I did one using this enigma PDF but with UPA. Mine didnt have the plastic piece with pins on board but just had the BDM holes.

[smartymarti]

There's also solder points for both versions so you don't ever have to remove needles

[Speedofix]

Car back again and PDF's not match.. I have take some pictures now..
Anyone know to wire this up or have pdf? I have DP3 only

[Speedofix]

Someone have PDF for nissan qasqai or rouge 2011 2012 for enigma or other tools ? just to check if it's look like this dash

[PremierD]

The 6 holes are there mate .... so the pin outs will be just the same . the needles are not that difficult to remove if you don't have hooks to do iy from the back

[markony79]

NO,
the nissan Navara is diferent from 2012
I was put here post about this year ago

the solder points is diferent for this dash, calcul for km( i can not remember)

i was post the my own pdf to Elprosys, but they never added in Dp3
anyway, can found self the soldering points, but the calcul i can not remember- its not the same like Qashqai !
on this dash the needles for speedometer and rpm go in down from 0 when the ingnition is off

[PremierD]

Listen mate ...I did one 6 days ago the ponits are where I said they were ... the op has found them.. :)

[markony79]

2012 MC9S12XHZ256

this you need ...SHORE ! :)

[smartymarti]

its a strightforward wire up up theres only 2 versions of this dash like tam says it can be done either rear of board of points arent there or needles off and do it from the front side , pending on your box theres also simple bdm points that you can solder onto saving hassles and time

[davecooper47]

Premier D and Marti are dead right. There is either the little white 6 pin socket or holes where the socket can go (otherwise known as bdm points). I have never had to remove the needles from one of these. The calculation is exactly the same as the old navara but in different address. Don't forget that this must be read as an "XHZ". Emphasis on the "X". Try it as the old HZ and your dump will be rubbish. It's exactly the same as the new qashqui if that helps.

[markony79]

Here you go

229164

haha...somebody copy my here my solder points, but OK

now i will post original my solder points here, and check it how its look like before its used it for upa

[Speedofix]

Haha.. Have no Internet connection for 2days.. Pin it out with mutimeter and done it last night:) and run it with Navara 9s12x software on dp3... THX anyway :)

[CARPARTS]

haha...somebody copy my here my solder points, but OK

This copy was a copy from the chinese copy who got your codiprog to copy.

[kokorocato]

upa weld points which is? navara 2012