********KD900 remote generator********

[autoTkey]

With NB remote you need to prepare the emulation of 7936 separately (I think it was after you prepare the remote you need to go to Chip Function > Chip Generation > and then maybe NB-Multi ZONE). Or the simple way - use a B remote and put a separate carbon PCF7936.

[Panathaole]

With NB remote you need to prepare the emulation of 7936 separately (I think it was after you prepare the remote you need to go to Chip Function > Chip Generation > and then maybe NB-Multi ZONE). Or the simple way - use a B remote and put a separate carbon PCF7936.


this is exactly the procedure that i follow..... remote works just fine, lock and unlock the car, my problem is that i can't add the key in to the immo system, when i add the keydiy, the original key lost the programming, when i add the original not possible to add the second one (keydiy...)......

i try to programming the remote as nissan pcf7946, and as nissan micra pcf7936.....

[autoTkey]

What tool you use for programming? Maybe you could try by EEPROM?

[rapidlocksmiths]

use B series remote and seperate pcf 7936

i assume you have correct pin .

[Panathaole]

i use DZ, i had programming many times keys in that kind of NATS......... of course i have the correct pin code, otherwise can't enter in programming mode....

so, is a key-remote problem?

[rapidlocksmiths]

not a problem with the remote as the remote is working fine , so this leaves the problem with either

the chip
the programmer used
or issue on car

have you used original pcf7936 ?

[autoTkey]

If car accept only one transponder it could be issue with the programmer, that's why I asked what is it.
Then next step would be to program one transponder and clone it on the second key....

[Panathaole]

not a problem with the remote as the remote is working fine , so this leaves the problem with either

the chip
the programmer used
or issue on car

have you used original pcf7936 ?


If car accept only one transponder it could be issue with the programmer, that's why I asked what is it.
Then next step would be to program one transponder and clone it on the second key....


i will try with another programmer, but i don't think is a programmer issue......

i was thinking about cloning the transponder.... but its an old lady.... (as i seed can't both transponder can accepted by the car..... only original or only the new can stay programmed...)

[kemaster]

Guys, does someone know if battery drain issue with generated Corolla'00-06 remote 89071- 0D010 onto B09-3 still exist?

[KILEX]

Yes, it works flawlessly on all 307 - old and new. Just need to find the correct data to download in the empty KD key. It depends on the car so you will have to try a few times until it works.
I have same problem as user VDO. 307 2004 I generate many remote on keydiy including CIR57, 307 OLD A, 307 OLD B none of them worked. After programing remote start working immediately or you have to synchronize it with car, if so how?

[autoTkey]

Basically it needs SYNC (IGN ON and keep one button pressed for 10 seconds) and then IGN OFF and wait 30-60 seconds to exit programming mode.