Problem with Reanult Scenic 2.0dci 160hp edc17 cp19 boot mode..

[obnchip]

Problem with Reanult Scenic 2.0dci 160hp edc17 cp19 boot mode..
Fgtech2 v51 read it and after write the mod file than car not start.Write back original "all"file but the car not start.
Anybody got experince like this??

[ludbe]

did you solder boot cable to boot pin? if you solder it and you are not careful, can make ecu in boot mode forever

[obnchip]

yes of course and its got 1000ohm

[pulsar2000]

yes of course and its got 1000ohm
what you put 10000 ohms on boot ?
or used the 1000 ohm boot wire, as im aware no resistor needed as on boot wire, anyway issue wont start,,,
file wrote ok etc ?
next thing maybe upload the mod file, see what went wrong and why,

[LaraVAG]

after write ori file, read it and compare. And give results

[gttuning]

Problem with Reanult Scenic 2.0dci 160hp edc17 cp19 boot mode..
Fgtech2 v51 read it and after write the mod file than car not start.Write back original "all"file but the car not start.
Anybody got experince like this??
have you comunication with ecu when reading DTC?

[obnchip]

yes its communicate but there is no check light...

[obnchip]

try with genuine renault diagnostic and a lot of things missing and error code's.So the dump not right for sure.galletto write not right or the read was even not right.
So now need to get a right dump or a virgin dump for this ecu.