View Full Version : Diagnostic 6CTA8.3-M4
aygo
17th November, 2013, 08:41 AM
Hello mates question for cummins expert.
Engine is marinized cummins 6CTA8.3-M4 46222057 year 2002 and need to make diagnostic with inline adapter. Where is located the diagnostic socket or wich type is ? Near the ecu i see 3pin deutsch connector but i dont know the pinout.
In this ecu maybe the diagnostic will be performed on the bench?
Thank you any help will be must apprecciated !!!
Regards
kitty-hawk
17th November, 2013, 10:04 AM
Hello,
You need this cable.
Cummins P/N 3165141
230379 230380
singleperson
19th November, 2013, 12:22 AM
Hi mate,
Could you help me, please? I would like to synchronize 2 Genset 6CTA8.3-M4 together by manual.
My alternator is stampford with AVR model : MX341.
Please give me your advice how to synchronize them. please help me with thanks
singleperson
19th November, 2013, 12:25 AM
Hi mate,
Sorry I mistake. This is model Engine: 6CTA8.3-GM155
Engine Serial: 87652369
aygo
22nd November, 2013, 06:27 PM
Ad informandum.
The diagnostic connector is a 9-pin deutsch located normally under console and not 3-pin deutsch.
The 3 pin deutsch is for external sensors in this case.
Or if you have multiple engines with the right cable is used also for sync.
aygo
22nd November, 2013, 06:51 PM
Hi mate,
Could you help me, please? I would like to synchronize 2 Genset 6CTA8.3-M4 together by manual.
My alternator is stampford with AVR model : MX341.
Please give me your advice how to synchronize them. please help me with thanks
For sync you must set one engine master and other slave with the right connectors (page 64 in pdf) and with insite calibrate the master engine if not purchased with right calibration with sync option enabled .
Put a connection cable between engines cummins p/n 4003624 (page 86 in pdf).
On my engines i have resolved in that way
Attached is pdf with installation methods and all explained verywell.
Regards
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.