View Full Version : Problem Read MC68HC11PA8 with upa usb
elremont
1st December, 2013, 03:16 PM
Hi
I have problem,connecting success,but read 2 errors found,where problem?
MASK 0D58J
I try read in circuit
Thanks
RadioChiP
1st December, 2013, 04:48 PM
Try this... Cut pin 25 from Printed Circuit Board end connect Gnd.
Osc 8mhz?
cut pin Rx Tx?
elremont
1st December, 2013, 05:30 PM
Try this... Cut pin 25 from Printed Circuit Board end connect Gnd.
Osc 8mhz?
cut pin Rx Tx?
Thanks Friend!
I try cut pin 25 and connect this pin to GND,add to radio Osc 10MHz and setup upa 10MHz and read OK.
Very Thanks.
RadioChiP
1st December, 2013, 09:17 PM
Good.No problem.
KrystianPoland
5th April, 2020, 11:20 AM
Topic is very old but j have the same problem-did you remebmer your conection? Which pins, voltage in radio off/on etc???
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.