PDA

View Full Version : HOw to BDM Bosch ME9 ford



ominimicu
14th December, 2013, 05:30 PM
So many people asking and also sick of trying to remove the PCB from the case...it is a total pain in the arse...i almost broke it. It is very difficut to acces the back of the PCB to BDM the BOSCH pads

So here is how to do it directly to FGtech without any adapters .

234968234967234969

here s small video too Bdm bosch me9 ford - YouTube (http://www.youtube.com/watch?v=JohHgppU-4A).
didnt had much time

NOTES: Do not feed FGtech 12v via round black supply cable!
i first read all and flash was partial, i then slectec flash only and flash was good
always let FGtech correct checksum even if you done it
use 13v or more

J_amb_o
15th December, 2013, 01:32 PM
Why would you need to pull back off when the pads are there as in your picture?

bondiblu
15th December, 2013, 02:17 PM
Why would you need to pull back off when the pads are there as in your picture? Because these are not "Bosch BDM" pads. BDM pads are on the back side of the PCB, this is a work-around method
using some other pads on the front side to help avoid damage.

moky
1st June, 2015, 05:23 AM
thanks a lot to ominimicu for help !!!!!!!!!!!!!!!!!!!!