ominimicu
14th December, 2013, 05:30 PM
So many people asking and also sick of trying to remove the PCB from the case...it is a total pain in the arse...i almost broke it. It is very difficut to acces the back of the PCB to BDM the BOSCH pads
So here is how to do it directly to FGtech without any adapters .
234968234967234969
here s small video too Bdm bosch me9 ford - YouTube (http://www.youtube.com/watch?v=JohHgppU-4A).
didnt had much time
NOTES: Do not feed FGtech 12v via round black supply cable!
i first read all and flash was partial, i then slectec flash only and flash was good
always let FGtech correct checksum even if you done it
use 13v or more
So here is how to do it directly to FGtech without any adapters .
234968234967234969
here s small video too Bdm bosch me9 ford - YouTube (http://www.youtube.com/watch?v=JohHgppU-4A).
didnt had much time
NOTES: Do not feed FGtech 12v via round black supply cable!
i first read all and flash was partial, i then slectec flash only and flash was good
always let FGtech correct checksum even if you done it
use 13v or more