Mercedec c w204 2011yr delphi crd3.10

[AutoM]

Had anybodu try to do this car over obd(galletto 2 or samething same). I have read it with galletto 2 without problems, but i am not try to write it because i can't find any pics of boot mod for this car. Any sugestions?

[smayer]

No need boot, galleto read and write over obd.

[AutoM]

Thx a lot m8! :D Thx!

[wiski]

Don't forget to put charger as it going to take some time writing :)

Sent from my GT-I9100

[smayer]

Don't forget to put charger as it going to take some time writing :)

Sent from my GT-I9100

yes, about 30 minutes writing.

[mecano_diag]

With Fgtech china clone?!!!

[CustomCars]

Yes galleto make it without problems..

[mecano_diag]

My fgtech china clone do not want to write
346390

[smayer]

Identify before write

[mecano_diag]

YEs identify,and reading correct,same prob with kess v2 clone ,reading correct and writing not start

[icezero2010]

YEs identify,and reading correct,same prob with kess v2 clone ,reading correct and writing not start


read and del the dtc`s after that you can write with kess . i have done many .

[smayer]

After see the file i supose you can?t write because car refuses to die so young :)

[adjee]

hi
have you some solution to write in CRD3 with fgtech or kess v2 china?

[sdtsedat]

One time i do this with Fgtech China, car no start.
Kess v5.017 red pcb china clone works good.

It will no write if your voltage is under 13,5V
I do this now with Kess geniune without problems,

Regards from belgium