Time setting problems with nlb 9341 again?

[KarlKiel]

Hello, I have the problem that time shown on screen is different from the one that is shown on the box in offline or standby mode with nlb9341 image. Ithink the problem happened before with ann earlier version - but was fixed in versions between. Anybody an idea on how to fix?

[aftermath]

go into local time settings and check your time zone, also turn daylight saving to on

also do a time update

[saki]

Hallo
This is a bug.
My ip 900 is almost ok.
Most of the time it is 1 hour late. If you update the time it will stay ok. 2 or 3 "power down`s" and then 1 hour late .
My 910 is 12 hours late all the time.
Best regards

[aftermath]

you can change the timezone to suit your correct time. +1, -1, +2, +3 e.t.c.

try this.

also if your connected to a network , use the update time as well.

[saki]

Hallo
It has been fixed in the sifteam 9580 release.
Hope to see NLB 9580 soon.
Best regards

[aftermath]

nice one...

glad you got sorted..

i am still on NLB 9341 and no problems with the time

[despdan]

I had same problem on NLB9207 but just went:

menu> system settings> local time settings> time setting> manual

[arashkhaan]

I have the same problem on 9000 and I have done anything which is said here !!! but I think the problem started after installing E2 on USB and using E2 sometimes, there is some problem using multiboot E! and E2 images

[aftermath]

if you are switching between E2 and flash image you will experience time changes, E2 normally is ok.

Its the flash image what changes the time, you need to update time in the setup options.

Or you could leave 1 image on all the time to guarantee the time is correct.

When i boot box after being on E2 image to flash i always update the time first before anything else.

I hope they can fix this bug as ive mentioned this to them many times

[arashkhaan]

Thank you so much for reply but after time update it changes the time again one hour,

[aftermath]

so you need to turn the daylight setting to on in the system settings > time settings

and check your timezone settings