Honda Accord 2.2 i-dtec edc17 infineon 1792

[saraivex]

Hello, i?m having troubles in extrating the files from this ecu. Doesn?t conect.

I have FGtech v52, and works fine but i haven?t done tricore. The pdf?s tell me to put a resistance of 1000ohm in the boot, but i notice in some youtube videos that some people don?t. They put the boot wire directly.

second question:

Do i have to read the 3 items? read all, read int flash micro, read eeprom.

In wich one are the maps to modify?

Tanks in advance

[sinan33]

Just put the boot cable directly to boot pin; the boot cable has 1000 ohm resistance on it.
You can get the full back up but you just need the flash for chip tuning.

[tunertool]

I think my tool have 1000 ohm resistance inside the cable but I always attached resistor and worked for me good.

[rachmach]

yes the cable have 1000 OHM no need to connect another resistor

[CustomCars]

Thank you for get out old topic.

Galleto using build in resitor at cable
Ktag no needed it too